OE Ref.:
42753-SWA-306
Commercial Name:
Pacific Clamp-in Gen Pacific Fixed Angle 315MHz Honda/Pacific
OEM Sensor P/N:
42753-SWA-306
Ean Code:
EZ-sensor® coverage:
YES
Nut Torque:
35.4 in-lbs (4 Nm) Nm
Screw Torque:
-- Nm
Valve Core Torque:
3.5 in-lbs (0.4 Nm) Nm
Note:
WARNING: This product contains chemicals including lead, which is known to the State of California to cause cancer and reproductive issues.
For more information, go to
www.P65Warnings.ca.gov.
EZ-sensor® GO is pre-programmed for all vehicles mentioned in the list. No programming is required before installation for the below applications. Additionally, the sensor can be programmed to 99% of all vehicle makes, models and years.
Click on item for more details:
This list is being continuously updated.
Part No.:
1109
20032
20032
Commercial Name:
TPMS Service Pack
Note:
Contents: 1 Aluminum Nut, 1 Plastic Sealing Cap, 1 Rubber Grommet, 1 Nickel Plated Valve Core, 1 Aluminum Washer
EZ-sensor® GO can be programmed to any Make Model and Year shown in this list.
Click on item for more details:
This list is being continuously updated.
Relearn Summary: Auto Relearn
Relearn DescriptionA properly formatted scan tool is required to learn new sensor IDs when replacing sensors.
After sensor IDs are registered to vehicle, the MIL will flash until the vehicle is driven and the sensors IDs are received by the vehicle.
This process could take 1-10 miles of continuous driving.
TIA troubleshooting tip: For Model Year 2008 plus on the Civic, Fit, and Odyssey (non-touring): After registering the new sensor IDs to the vehicle via the OBDII, remove the valve core on the new sensor(s), allowing tire to complete deflate.
Then inflate tire to operating air pressure, install valve core and verify correct air pressure with a calibrated air pressure gauge.
While deflating tire(s) ensure vehicle weight is supported on a lift to avoid damage to the tire.
By performing a rapid deflate/inflate in the new sensor(s) this enables the sensor(s) to fully activate and communicate with the vehicle.
In some cases, the MIL will cease to flash after full deflation/ inflation, drive vehicle 1-10miles to get MIL to stop flashing if it does not stop after deflation/inflation.
Relearn Procedure as PDF document
Mounting Instructions
Note:
Sensor images shown in this document are for illustration purpose only!
Phisical sensor body may be different.
Non contractual document!
For tecnical information, please contact your supplier or leave a message at info@Schrader TPMS E-Catalog.com
User Manual/Quick Start Guide
Note:
Document contains full description user manual and / or Quick Start Guide. Non contractual document!
For technical information, please contact your supplier or leave a message at SchraderNA@sensata.com
Approvals and Declarations
Note:
Package contains FCC, IC and CE certifications
Physical sensor body may be different.
Other documents can be also found
here.